Lincoln 2009 MKZ User Manual download pdf (Page 47)

Replacing redundant park bulbs

1. Make sure headlamp switch is in the off position, then open the hood.

2. Remove screw from oval splash

shield access panel from the

exterior wheel well area. Lift up and

rearward to release a hidden finger

attachment at the lower portion of

the panel.

3. From the exterior wheel well

area, reach arm through splash

shield opening to access bulb

socket.

4. Remove the bulb socket by

rotating it counterclockwise, then

pulling it out of the lamp assembly.

5. Let go of the bulb socket and

leave it dangling near the lamp

housing.

6. Reach over the front bolster in

the engine area and, with a tool if

necessary, bring the bulb socket

upwards into an unobstructed area to replace the bulb.

7. Carefully pull bulb straight out of

socket and push in the new one.

8. After the new bulb is installed,

carefully let the bulb socket dangle

downward near the lamp housing.

9. From the exterior wheel well

area, reach arm through splash

shield opening to install bulb socket

with new bulb.

10. Install the new bulb socket into the lamp assembly by aligning the

indexing fingers, then rotate clockwise to the locked position.

11. Reinstall splash shield with screw.

12. Reinstall air tube to the air filter assembly (driver side only).

2009 MKZ (378)

Owners Guide

USA (fus)

Lights

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 291 292

No comments

Lincoln 2009 MKZ User Manual Page 47